|
Fully conforming to the requirements of
CISPR 16
The TTi LISN 1600 is a network which is placed between the AC line supply
and the equipment under test in order to accurately measure the
interference that the equipment is emitting at its supply input.
Regulations now exist that will place statutory limits upon these
emissions. These regulations refer to the standard CISPR 16. The LISN 1600
is intended for use with either a spectrum analyser or a measurement
receiver. When used with a measurement device of suitable performance it
can be used for actual conformance measurements.
16 Amps continuous current rating
The LISN 1600 has a continuous current rating of 16 Amps (except where
limited by the fitting of a lower rated connector at the input or output).
This makes it suitable for use with virtually all types of single phase
equipment.
9kHz to 30MHz range for measurements
in bands A & B
CISPR 16 defines two measurement bands: band A for 10kHz to 150kHz and
band B for 150kHz to 30MHz. The LISN 1600 correctly meets the impedance
requirements for both bands.
A switchable 150kHz high pass filter is incorporated to limit low
frequency signals (particularly AC line frequency) when measuring in band
B. This helps limit the dynamic range requirements of the measuring
device. In addition, an extended frequency characteristic allows useful
measurements to be made up to 100MHz.
|
|
Manual and remote control of source selection
The measurement circuit can be connected to either supply line or
disconnected altogether for checking the noise floor. Where automated
measurement sequences are required, source selection can be performed
remotely via built-in relays.
Built-in voltage limiter and attenuators
The LISN 1600 incorporates a voltage limiter to protect the vulnerable
input of the measuring device against damage from power-switching or
interference transients.
To avoid the risk of introducing nonlinearity errors, the limiter diodes
are held in reverse bias by built-in lithium batteries. The limiter has a
10dB pre-attenuator and a switchable 10dB post-attenuator. If required,
the whole limiter/attenuator network can be switched out.
The switchable 150kHz filter provides further protection when making band
B measurements.
Artificial hand terminal for hand-held equipment
For testing hand-held apparatus which does not have an earth connection,
an artificial hand terminal is provided. This conforms to the definitions
in BS800 and EN55014.
|
Suitable for full conformance
measurements
